Most Common Hot Water Systems Installation Mistakes That You Should Avoid

By  |  0 Comments

Most Common Hot Water Systems Installation Mistakes That You Should Avoid

Your hot water systems installation, whether it is an electrical system or a gas heater is designed to make a reliable and steady supply of hot water for your residence.

When you want to perform hot water system installation there are several essential details which are often overlooked & this affects the overall performance of your system. Therefore, we have jotted down the commonest mistakes that you should avoid. The most common hot water system installation mistakes that you should avoid.

Installing a hot water system? Be aware of these mistakes

Homeowners often make several mistakes during installation that prevent the water heater from working very efficiently. At times have certain catastrophic effects which would be certainly hard to modify. That’s why it is always advisable to hire a professional for hot water system installation. If you want to install the system by yourself; avoid the below-listed mistakes to enjoy an uninterrupted flow of hot water. These are the most common hot water system installation mistakes that you should avoid.

1. Purchasing the Wrong Sized Hot Water System

Most of the times, several homeowners purchase water heaters which are not just the right-sized model for their customized needs. Typically two and a half shower bath requires 50 gallons of hot water. Depending on your requirements, choosing the best-fit model will also ensure you are not left out dry for hot water; when you require it the most. On the other hand, purchasing a too large system wastes a lot of water, time and money. Therefore, you require professional guidance in the right direction to purchase the best hot water system. First, identify your daily consumption of hot water and then buy a hot water system accordingly.

2. Soldering Fittings Just on the Top of the Water Heater

When you opt for the water installation or even a replacement of your old system; a very common DIY mistake is to solder the fittings very close to the tank. To avoid the heat melting the dip-tube or any of the plastic fittings and cause some serious damage to the water heater. The experts advise that you unscrew the solder and nipples on the fittings separately away from the water heater.

3. Using Metal Pipes Which Are Incompatible

When you have undertaken hot water installation or perform a hot water replacement; you ought to pay close attention to the compatibility in between the two metal pipes. The proper installation of the hot water system will be comparatively easy; if your tank has copper or brass connectors, and the pipes in your home are of copper. In case the pipes in your house are made up of galvanized steel; a skilled plumber will always use a dielectric union. In order to prevent these two pipes to come into contact with another and create an electric-corrosive charge. Which in turn would weaken the pipe and result in leakages.

4. T&P Overflow Valve

In most water heaters, there is a temperature and pressure valve attached. Which release a high amount of heat or pressure inside the water heater. If this particular safety valve is not properly installed; the water tank has high chances of exploding or spraying bystanders with the boiling hot water. If it is not properly dejected down the pipe. An experienced plumber will do much more than just install the T&P valve outlet & route the tube to the floor to safely divert any of kind of dangerous discharge.

5. Dry Firing

Once you have installed the hot water system, it is crucial to not turn the circuit on; until the heater is completely full of water. Once the hot water system installation is complete, you need to ensure that you purge out the existing air from the tank by opening the hot water faucet & wait until you get an uninterrupted flow of water. After this, you can turn on the water heater. This of prime importance as dry firing the water heater can extremely overheat & ultimately crack the concerned tank.

If you are planning to have a hot water system installation, you should keep the above-discussed points in mind. Properly installed hot water system serve you the best for a longer period of time without any sudden malfunction. If you think that this is too much work for DIY, then you can always opt for a professional hot water system technician for worry-free installations.

[userpro template=postsbyuser user=author postsbyuser_num=4]

Leave a Reply

Your email address will not be published.